Metlund D'MAND Recirculation Systems

Metlund D'MAND
Now you can have hot water in 15-30 seconds (depending on the size of the home and water system) without wasting a single drop and by using only a fraction of a penny's worth of electricity.

The Metlund^® Hot Water D'MAND^®System integrated controller and electronic zone valve), requires no special plumbing. It is designed for use with any hot water heating system to provide energy and water savings. It's easy to install in new or existing homes or businesses. For more in on the benefits of a recirculation system, please click here.

Return to the Catalog
View Next Products

Metlund S-50T
Description: The S-50T models are smaller pump systems designed for smaller homes. They weigh 6 lbs. Dimensions are 8" wide, 7½" deep, and 5½" tall. (This model is not recommended for gas tankless water heaters. Please review the tankless water heater section on the Metland D'MAND site for further information).

The patented PDV (Check Valve) is built into the pump housing, reducing the number of external devices. The S-50T models are adequate for runs of under 50 feet. The S-50T models carry a three year warranty.

The S-50T is available in three configurations. The base configuration is the S-50T-PF Kit. Click on any model number above to add that item to the shopping cart. (If you want to buy more than one, you can change the quantity in the cart later).

Patented D’MAND circuit board and PDV (Check Valve). Two ½" threaded male adapters pre-assembled for easy installation, two brass “T” compression fittings, two stainless steel flex-lines, one hard-wired button.For runs under 50 feet.

You can also upgrade to the S-50T-PF-R Kit which includes one remote control package OR You can upgrade to the S-50T-PF-V-102 Kit which includes one hard hardwired motion sensor.

Back to top

Metlund S-70T
Description: The S-70T models are designed for homes under 3500 square feet. They are suitable for use in most homes and small businesses. They weigh 7 lbs. Dimensions are 11" wide, 8" deep, and 6" tall. (This model is adaptable to any tankless water heater. Please review Metlund's tankless water heater section for proper sizing).

The patented PDV (Check Valve) is built right into the pump housing, reducing the number of external devices. It is adequate for runs of up to 100 feet. The pump carries a five year warranty.

The S-70T is available in three configurations. The base configuration is the S-70T-PF Kit as shown below. Click on any model number above to add that item to the shopping cart. (If you want to buy more than one, you can change the quantity in the cart later).

You can also upgrade to the S-70T-PF-R Kit which includes one remote control package OR You can upgrade to the S-70T-PF-V-102 Kit which includes one hardwired motion sensor.

Metlund S-02T
Description: S-02T models are designed for use in large homes or commercial buildings where the distance from the water heater to the farthest fixture is greater than 100 feet. The S-02T models carry a five year warranty and weigh 16 lbs. Dimensions are 16" wide, 9" deep, and 6½" tall. (This model is adaptable to any tankless water heater. Please review Metlund's tankless water heater section for proper sizing).

The D’MAND System is available in four models. Click on any model number above to add that item to the shopping cart. (If you want to buy more than one, you can change the quantity in the cart later).

The patented D'MAND Circuit Board, pump with built in IFC valve, flanges, two copper “T” compression fittings, and two stainless steel flex-lines for easy installation.

You can also upgrade to the S-02T-PF-R Kit which includes one remote control package. OR You can upgrade to the S-02T-PFV-102 Kit which includes one hardwired motion sensor OR You can choose the general S-02T where no check valve is required.

Return to the Catalog