Eccotemp
Warranty Information
Listed below is our warranty information as it pertains to our models as it
applies to freezing.
Eccotemp makes no other claims, expressed or implied herein.
LIMITED WARRANTY
Outdoor model numbers 40H-NG, 40H-LP, 40HI-LP, L10-AC and indoor model numbers
40HI-NG, 40HI-LP have an antifreeze protection circuit installed on the units.
This circuit will protect the units down to -30 degrees F from freezing.
Note: THIS DOES NOT COVER FREEZING FROM FROZEN WATER IN THE PIPES.
FROZEN WATER IN THE INCOMING OR OUTGOING WATER LINES MAY CAUSE A RUPTURE IN THE
HEAT EXCHANGER AND PIPES. ECCOTEMP SYSTEMS, LLC ALSO RECOMMENDS THE
APPROVED VENT KITS FOR 40HI-NG, 40HI-LP INDOOR MODELS. USING A VENT KIT
WITHOUT A BACKFLOW PREVENTER MAY CAUSE DAMAGE.
In
order to prevent this, you must take the following steps:
-
Ensure that the unit is plugged in and there
is electricity being supplied at that outlet
-
YOU MUST ENSURE THAT THE PIPES ARE INSULATED
WITH HEAT TAPE or YOU MUST KEEP THE WATER ON AT A TRICKLE TO ENSURE NO
FREEZING INCURS
-
Your vent kit must have a back-flow preventer
to ensure cold air does not backflow through to the heat exchanger and risk
freeze damage.
ECCOTEMP SYSTEMS, LLC WARRANTY WILL NOT COVER RUPTURES IN ITS SYSTEMS DUE TO
FROZEN WATER IN THE PIPES. It is the homeowner and/or installers
responsibility to ensure that the incoming and outgoing water lines are properly
insulated and protected against freeze.
Outdoor model numbers L5, L10 DO NOT have an antifreeze circuit installed.
If the temperatures get at or below freezing, you must drain the unit by
unscrewing the drain stem located at the bottom right of the unit AS WELL AS
unhook the outgoing water line to ensure proper drainage from the heat
exchanger.
Please click here for more information on our
warranty policy.
|